correckt spelleing mistake

embadet/readme.md

@@ -1,24 +1,23 @@
 # Info
-## Important comands
-Comand for build options of the projeckt\
+## Important Commands
+Command to configure build options of the project:  
 `make menuconfig`
 
-Comand for flashing\
+Command to flash the firmware:  
 `make flash`
 
-Comand for showing the serial monitor\
+Command to show the serial monitor:  
 `make monitor`
 
-## Connection error
-If you get the error [Errno 2] you propiply dident conneckt the microcontrorloer or hav the wrong tty selectet.
-to select the right tty use comand `make menuconfig` and then go to **serial flasher config -> Default serial port**
-then change to the right port
+## Connection Error
+If you encounter the error `[Errno 2]`, it likely means the microcontroller is not connected or the wrong tty port is selected.  
+To select the correct tty port, use the command `make menuconfig`, then navigate to **Serial Flasher Config -> Default Serial Port** and choose the correct port.
 
-## Sensor isshus
-if the out put of the sensor is atound **80°** you have a power conection ishue. \
-if you got the output around **-127°** sense wire not conectet.
+## Sensor Issues
+If the sensor output is around **80°C**, there is likely a power connection issue.  
+If the output is around **-127°C**, the sensor's data wire is probably not connected.
 
-## Compiling errors
-when the temp input is non it mid be a compyling error caude by a falty sdk configuration \
-so use the command ```make menuconfig``` to chaing the following settings \
-**Component config -> newlib -> disable nano formatting**
+## Compilation Errors
+If the temperature input is `none`, it might be due to a compilation error caused by an incorrect SDK configuration.  
+Use the command `make menuconfig` and change the following settings:  
+**Component config -> newlib -> Disable nano formatting**